Pontiac Vibe Navigation System Supplement - Manual (Page 36)

3-3
Playing the Radio
The audio system can be operated using the knobs
and hard keys located on the both sides of the
navigation screen.
PWR (Power): Press this knob to turn the audio and
navigation systems on and off.
VOL (Volume): Turn the knob to increase or to
decrease volume.
SCV (Speed Compensated Volume): With this
function, your audio system adjusts automatically to
make up for road and wind noise as you drive. Set the
volume at the desired level. Then, as you drive, this
function automatically increases the volume, as
necessary, to overcome noise at any speed. The volume
level should always sound the same to you as you drive.
BAND: Press this hard key to access the BAND screen
and to switch between AM, FM1 and FM2. Each radio
band has six station presets accessible.
Finding a Station
TUNE: Use the control pad in the lower left corner of
the navigation system to select radio stations manually.
∧
SEEK
∨
: Press the up or the down arrow to go to
the next or the previous station and stay there.
To scan stations, press and hold the SEEK up or down
arrow for two seconds until you hear a beep. The radio
will go to a station, play for a few seconds, then go on
to the next station. Press either SEEK arrow again to
stop scanning.
To scan preset stations, press and hold the SEEK up or
down arrow for more than four seconds. You will hear
two beeps and PSCAN will be displayed, along with the
number preset. The radio will go to the first preset
station stored on your pushbuttons, play for a few
seconds, then go on to the next preset station. Press
either SEEK arrow again to stop scanning presets.
The radio will seek and scan only to stations that are in
the selected band and only to those with a strong signal.