Pioneer S-LX70C - Manual (Page 3)

E
ng
li
sh
F
ra
n
ç a
is
E
sp
a
ñ
o
l
3
En
Confirm your accessories
• Speaker stand x 1
• Bracket (for speaker/S) x 1
• Bracket (for speaker/L) x 1
• Bracket (for wall) x 1
• Screw (long) x 4
• Screw (short) x 2
• Non-skid pad x 1 (set)
• Gasket (for speaker stand) x 1
• Self-adhering fastener (hook) x 2
• Self-adhering fastener (loop) x 2
• Cleaning cloth x 1
• Wall mounting template x 1
• Operating instructions
Speaker system grill
The speaker system grill cannot be removed. Do not try to forcibly
remove it since doing so may damage the grille.
Installing the speaker
This speaker system cannot be placed directly on the surface of
floors or shelves. Always attach to a wall using the supplied
brackets, or place on a flat and secure surface using the supplied
speaker stand.
• This speaker system is magnetically shielded. However,
depending on the installation location, color distortion may
occur if the speaker system is installed extremely close to the
screen of a television set. If this happens, turn the power switch
of the television set OFF, and turn it ON after 15 to 30 minutes.
If the problem persists, place the speaker system away from the
television set.
Mounting on walls
Once decided on the location of installation (such as the wall space
above or below of the TV), attach the speaker following the next
procedures.
Two types of brackets (for speaker) are supplied. When using
alongside with a Pioneer plasma television, use the L-type bracket.
When attaching flush against the wall, use the S-type bracket.
1 Connect speaker cable.
• Speaker cable is not included with this speaker system.
This speaker does not include speaker cables used for connecting
to an amplifier. Take the following factors into consideration when
choosing speaker cables so that you can get the most from your
speaker system:
• Use heavy-gauge speaker cable if possible, and keep the cables
to the minimum necessary length.
• Cables have differing characteristics. Keep this in mind when
using any cable.
• Connections at speaker and amplifier terminals should be
made as tight and secure as possible to help reduce contact
resistance.
When mounting the speaker onto wall using the bracket, connect
the speaker cable before attaching speaker onto the bracket.
• Make sure that the wall you intend to mount the speaker on is
strong enough to support it.
• Remember that the speaker system is heavy. Improper
installation of the speaker could cause it to fall and cause
damage or injuries to persons nearby.
• Mounting screws are not supplied. Use screws suitable for
the wall material and support the weight of the speaker.
If you are unsure of the qualities and strength of the walls,
consult a professional for advice.
S_LX70-C_En.book 3 ページ ２００７年９月２８日 金曜日 午後５時４２分