Panasonic CQ-D5501U - Manual (Page 32)

62
61
E
N
G
L
I
S
H
CQ-D5501U
63
62
E
N
G
L
I
S
H
CQ-D5501U
Above Specifications comply with EIA standards.
Specifications
Power supply : DC 12 V (11 V - 16 V), test
voltage 14.4 V, negative
ground
Current consumption : Less than 2.3 A (CD mode,
0.5 W 4-channels)
Maximum power output : 50 W x 4 (at 1 kHz)
volume control maximum
Video Signal system : NTSC/PAL 1.0 Vp-p 75 Ω
RCA pin jack
Tone/SQ adjustment range : SQ Low/Bass: ± 12 dB (at 60
Hz, 80 Hz, 100 Hz, 200 Hz)
SQ Mid: ± 12 dB (at 500 Hz,
1 kHz, 2 kHz, 3 kHz)
SQ High/Treble: ± 12 dB (at
10 kHz, 12 kHz, 15 kHz,
18 kHz)
Speaker impedance : 4 - 8 Ω
Pre-amp output voltage : 2 V (CD mode, 1 kHz, 0 dB)
Subwoofer output voltage : 2 V
Pre-amp output impedance : 200
Ω
Subwoofer output impedance : 200 Ω
Dimensions (W x H x D) : 178 x 50 x 160 mm
{7 ” x 1 15 / 16 ”x 6 5 / 16 ”}
Weight : 1.8 kg
{3 lbs. 16 oz}
General
Frequency range : 87.9 MHz - 107.9 MHz
Usable sensitivity : 10.2 dBf. (0.9 µV, 75 Ω)
50 dB quieting sensitivity : 15.2 dBf. (1.6 µV, 75 Ω)
Frequency response : 30 Hz - 15 kHz (±3 dB)
Alternate channel selectivity : 75 dB
Stereo separation
: 35 dB (1 kHz)
Image rejection ratio : 55 dB
IF rejection ratio : 100 dB
Signal to noise ratio : 62 dB
Frequency range : 530 kHz - 1 710 kHz
Usable sensitivity : 27 dB/µV (22 µV, S/N 20 dB)
DA converter : 1 bit DAC System
Pick-up type : Astigma 3-beam
Light source : Semiconductor laser
Frequency response : 20 Hz - 20 kHz (CD)
: 20 Hz - 22 kHz (DVD video
48 kHz sampling)
: 20 Hz - 44 kHz (DVD video
96 kHz sampling)
Signal to noise ratio : 95 dB (IHF, A)
Wow and flutter : Below measurable limits
Disc Player
AM Radio
FM Stereo Radio
Power Output:
18 W RMS x 4 Channels at 4
Ω and ≤ 1%
THD+N
Signal to Noise Ratio:
85 dBA (reference: 1 W into 4
Ω)
Note:
¡Specifications and design are subject to modification
without notice due to improvements.
¡Some figures and illustrations in this manual may be
different from your product.
Troubleshooting
(continued)
Display
The disc is dirty.
The disc has scratches.
a Eject the disc.
Possible cause a Possible solution
Error Display Messages (continued)
■ DVD/VCD
The disc is upside down.
The player for some reason cannot read the file you are trying to play.
(File recorded in an unsupported file system, compression scheme, data
format, file name extension, damaged data, etc.)
a Eject the disc. Select a file that the player can read. Confirm the type
of data recorded on the disc. Create a new disc if necessary.
The player will not operate for some reason.
a Eject the disc. If the disc is not ejected when you press [u] (eject),
unplug the power cord and plug it again. In case the unit is still out of
order, consult your dealer.
This disc may not be played in your region.
An attempt was made to play a disc with a region number that was not “1”
or “ALL”.
a Eject the disc.
Linear PCM (2ch) (32 kHz/44.1 kHz/48 kHz sampling/16 bit) MP3 MP3
Linear PCM (2 ch) (44.1 kHz sampling/16 bit)
DTS bitstream (1 - 5.1ch) (The analog portion is not output.) Linear PCM
DTS* CD
MPEG 1 bitstream
Linear PCM (2 ch) (44.1 kHz sampling/16 bit) MPEG 1
Linear PCM Video CD
Dolby Digital bitstream (1 - 5.1ch)
DTS bitstream (1 - 5.1ch) (The analog portion is not output.)
Liner PCM (2 ch)
(48 kHz sampling/16 bit) Dolby Digital
DTS*
Liner PCM
(48 kHz 16/20/24 bit) DVD
Optional digital audio output from connector Sounds recording format Disc
Digital audio output
Discs played
(1) DVD-Video disc
12 cm {5 “} single-sided, single-layer/double-layer
12 cm {5 “} double-sided, single-layer/double-layer
8 cm {3 “} single-sided, single-layer/double-layer
8 cm {3 “} double-sided, single-layer/double-layer
(2) Compact disc (CD-DA, Video CD, CD-R, CD-RW)
12 cm {5 “} disc
8 cm {3 “} disc
*DTS only works optical outputs.