Panasonic WV-C L924A - Manual (Page 29)

-30-
• Whenever the multiplexed vertical drive pulse (VD2)
is supplied to the camera from an external equip-
ment such as a Matrix Switcher, the camera sync
mode is automatically switched to the VD2 mode.
• When the VBS or VS gen-lock mode is to be used
select INT from this menu and supply the gen-lock
input signal to the Gen-lock Input Connector on the
rear panel.
• The VBS gen-lock mode has a submenu for hori-
zontal and subcarrier phase adjustments. When the
cable length of the video output or the gen-lock
input is changed, the horizontal and subcarrier
phase must be re-adjusted.
• The VS gen-lock mode has a submenu for horizon-
tal phase adjustments. When the cable length of
the video output or the gen-lock input is changed,
the horizontal phase must be re-adjusted.
• The line-lock mode has a submenu for line-lock ver-
tical phase adjustment. If the camera installation is
relocated, check the vertical phase adjustment
again since the AC line phase may be different.
Notes:
• While the SENS UP function is active, the increased
sensitivity may cause noise, spots or a whitish phe-
nomenon to appear in the picture. This is a normal
phenomenon.
• x64 FIX does not appear for the SENS UP parame-
ter on the system controller setup menu.
• In case of using the WV-CU204 or WV-CU254
Controller, status does not appear correctly for the
SENS UP parameter on the setup menu.
6. Synchronization Setting (SYNC)
Rules on synchronization
• The priorities for the sync mode are as follows. A
higher mode will overrule lower ones.
1. Multiplexed Vertical Drive (VD2) (Highest priori-
ty)
2. Line-lock (LL)
3. Color Composite Video or Blackburst Signal
(VBS)
4. B/W Composite Video or Composite Sync
Signal (VS)
5. Internal Sync (INT) (Lowest priority)
• When the internal sync mode is to be used, select
INT. No gen-lock input signal should be supplied to
the Gen-lock Input Connector on the rear panel.