Panasonic WV-C L924A - Manual (Page 22)

-23-
1. Camera Identification (CAMERA ID)
Setting
You can use the camera identification (CAMERA ID)
menu to assign a name to the camera. The camera ID
consists of up to 16 alphanumeric characters. The cam-
era ID display can be switched on or off on the monitor
screen.
Camera ID ON/OFF
Move the cursor to CAMERA ID, and select ON or OFF.
ON: Displays the camera ID in the specified position on
the monitor.
OFF: Does not display.
To edit the CAMERA ID
1. Press I. The CAMERA ID menu appears. The
cursor on the letter “0” is highlighted.
2. Move the cursor to the character you want to edit
by pressing
L/M/J/K.
3. After selecting the character, press I. The
selected character appears in the editing area.
(The pointer in the editing area moves to the right
automatically at this moment.)
4. Repeat the steps above until all characters are edit-
ed.
To enter a blank space in the CAMERA ID
Move the cursor to SPACE and press
I.
To replace a specific character in the CAMERA ID
1. Move the cursor to the editing area by pressing
K.
SETTING PROCEDURES
Character Cursor
Pointer
Character
Area
Command
Editing
Area
CAMERA ID menu
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$
SPACE
POSI RET END RESET
................
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵
↵