Multi-zone setup, Making multi-zone connections, Connecting your equipment 03 – Pioneer VSX-919AH-S User Manual
Page 31: Multi-zone listening options, Basic multi-zone setup (zone 2), Multi-zone setup using speaker terminals (zone 2), With video signals, Main zone sub zone vsx-1019ah
Connecting your equipment
03
31
En
MULTI-ZONE setup
This receiver can power up to two independent
systems in separate rooms after you have
made the proper MULTI-ZONE connections.
Different sources can be playing in two zones
at the same time or, depending on your needs,
the same source can also be used. The main
and sub zone have independent power (the
main zone power can be off while sub zone is
on) and the sub zone can be controlled by the
remote or front panel controls. However, you
may need to specify the volume settings in
ZONE Audio Setup on page 98.
Making MULTI-ZONE connections
It is possible to make these connections if you
have a separate TV and speakers for the sub
zone (ZONE 2). You will also need a separate
amplifier if you are not using the MULTI-ZONE
setup using speaker terminals (ZONE 2) below
for the sub zone.
MULTI-ZONE listening options
The following table shows the signals that can
be output to ZONE 2:
Basic MULTI-ZONE setup (ZONE 2)
•
Connect a separate amplifier to the AUDIO
ZONE 2 OUT jacks and a TV monitor to the
VIDEO ZONE 2 OUT jack, both on this receiver.
You should have a pair of speakers attached to
the sub zone amplifier as shown in the
following illustration.
MULTI-ZONE setup using speaker
terminals (ZONE 2)
You must select ZONE 2 in Surround back
speaker setting on page 93 to use this setup.
Note that the sound in the sub zone will be
temporarily interrupted when controlling the
main zone (for example, changing the input
function or starting playback).
•
Connect a TV monitor to the VIDEO ZONE
2 OUT jacks on this receiver.
You should have a pair of speakers attached to
the surround back speaker terminals as shown
below.
Sub Zone Input functions available
ZONE 2
Analog audio signals (AUDIO ZONE 2
OUT).
a
With video signals,
b
the composite
video (VIDEO ZONE 2 OUT) signals
can be output.
a.Any analog signal. (This does not apply for the MULTI
CH IN input.)
b.JPEG files cannot be played with the USB input.
ASSIGNABLE
DVD
IN
MONITOR
OUT
VIDEO
COMPONENT
VIDEO
ZONE 2
AUDIO
OUT
L
Y
PB
PB
PR
Y
PB
PR
PR
Y
R
BD IN
IN
1
IN
1
IN
2
(DVD)
(DVR)
R
L
AUDIO IN
VIDEO IN
Main zone
Sub zone
VSX-1019AH
ASSIGNABLE
DVD
IN
MONITOR
OUT
VIDEO
COMPONENT
VIDEO
T
ZONE 2
AUDIO
OUT
L
Y
PB
PB
PR
Y
PB
PR
PR
Y
R
BD IN
IN
1
IN
1
IN
2
IN
(DVD)
(DVR)
WOOFER
L
L
(Single)
R
ND
SURROUND BACK /
AM
LOO
FM
UN
75
OUT
VR)
B
VIDEO IN
R
L
Main zone
Sub zone
VSX-1019AH
VSX-1019_DF.book 31 ページ ２００９年３月１３日 金曜日 午前９時５８分