Planet Technology VIP-154T User Manual
Page 17
17
3 Phone
setting
3.1 Call
forward
3.1.1 All Forward
3.1.1.1 Activation: To Enabled/Disabled this function.
3.1.1.2 Number: Forward to a Speed Dial Number.
3.1.2 Busy Forward
3.1.2.1 Activation: To Enabled/Disabled this function.
3.1.2.2 Number: Forward to a Speed Dial Number.
3.1.3 No Answer Forward
3.1.3.1 Activation: To Enabled/Disabled this function.
3.1.3.2 Number: Forward to a Speed Dial Number.
3.1.4 Ring Timeout: Set the Ring times to start the no answer
forward function, ex: 2 means after 2 rings then forward to
the dedicated number.
3.2 Block
Setting
3.2.1 All: To Enabled/Disabled this function.
3.2.2 By Time: To Enabled/Disabled this function.
3.2.3 Duration: Set the block time.
3.3
Date/Time setting: Date and Time Setting.
3.3.1 Date & Time: Set the IP Phone Date and Time.
3.3.2 SNTP setting
3.3.2.1 SNTP: Enabled / Disable SNTP.
3.3.2.2 Primary SNTP: Set Primary SNTP server IP address.
3.3.2.3 Secondary SNTP: Set Secondary SNTP server IP
address.
3.3.2.4 Time zone: Set Time zone.
3.3.2.5 Adjustment Time: Set adjustment time period.
3.4
Volume and Gain
3.4.1 Handset volume: Set Handset volume from 0~15 (max.) for
you to hear.
3.4.2 Speaker volume: Set Spearer phone volume from 0~15
(max.) for you to hear.
3.4.3 Handset Gain: Set Handset Gain from 0~15 (max.) for the
other site to haer.
3.4.4 Speaker Gain: Set Spearer phone Gain from 0~15 (max.) for
the other site to haer.
3.5 Ringer
3.5.1 Ringer volume: Ringer volume setting from 0~15 (max.).
3.5.2 Ringer type: Ringer tone selection from 1~4.
3.6
Auto Dial: Set Auto Dial time from 3~9 seconds.
3.7 Pick
up
3.8 Voicm
Mall
4 Network
4.1 IP
Setup
4.1.1 IP Type
4.1.2 Fixed IP client
4.1.2.1 IP Address / Subnet mask / Default Gateway
4.1.3 DHCP client
4.1.3.1 User name / Password
4.1.4 PPPoE client:
4.1.4.1 PPPoE setting
4.1.4.2 User name / Password
4.2 DNS
4.2.1 Primary DNS /
4.2.2 Secondary DNS
4.3
Status: Show LAN IP address and MAC address
5 SIP
Settings
5.1.1 If you want to use Kaypad to set the SIP setting, you have to
go to item 7 (Administrator) System Authent to input the
password (Default is “null” (not password)), or you can not
change the SIP setting.