Polycom 3725-24004-001/A - Manual (Page 23)

Using the Polycom PowerCam Presenter
2 - 11
Enabling and Disabling Automatic Camera Tracking
Most of the time, you’ll want to keep automatic tracking on so you can freely
move about the room without having to manually adjust the camera.
However, at times, you may want to manually pan, tilt, and zoom the camera.
The Polycom PowerCam Presenter gives you the flexibility to enable or disable
automatic camera tracking.
For information about how to manually control the camera, refer to
Controlling the Camera Manually on 2-15 .
To enable automatic camera tracking:
1. Slide the Power button on the locator pack to the ON position.
The camera remains in the state it was when you last powered off the
locator pack. Therefore, if automatic camera tracking was disabled the last
time you powered off the locator pack, it will be disabled when you power
on the locator pack; if automatic camera tracking was enabled, then it will
already be enabled when you power on the locator pack.
2. If automatic camera tracking is disabled, press any of the Presenter View
buttons.
To disable automatic camera tracking:
¾ Do one of the following:
— Power off the locator pack by sliding the Power button on the top of
the locator pack to the OFF position.
— Press Off on the remote control.
— Press Preset 1 or Preset 2 on the remote control.
If you are using a VSX video conferencing system with your PowerCam
Presenter, automatic camera tracking automatically becomes disabled if the
far site controls your camera using Far End Camera Control. You can also
disable it by doing one of the following:
• Manually pan, tilt, or zoom the camera or select a preset using either the
VSX remote control or VSX Web.
• Use VSX automatic tracking to voice.
Off