Powerware BestLink IPK-0319 - Manual (Page 11)

Installation
5 BestLink SNMP/WEB Adapter User’s Guide
:
LTM-1343 B Draft 10/03/2001
4. Connect an active 10BaseT cable to the network connector on the
BestLink Adapter.
5. Insert the power adapter DC power plug into the power connector
on the back of the BestLink Adapter (labeled 12 VDC).
6. Plug the power adapter into a UPS output receptacle.
7. Continue to the following section “Configuration.”
Set both DIP switches
to the
0 (off) position
1
0
Cable labeled “UPS” to
UPS serial port and
BestLink Adapter UPS port
Power cable to BestLink
Adapter power inlet and
UPS receptacle
To LAN port
Figure 3. Installing the External BestLink Adapter