Plantronics T10 - Manual (Page 4)

UK
5. Do not place this product on an unstable cart, stand or table. The product may fall,
causing serious damage to the product.
6. Slots and openings in the base unit and the bottom or back are provided for
ventilation, to protect it from overheating; these openings must not be blocked or
covered. The openings should never be blocked by placing the product in the bed,
sofa, rug or other similar surface. This product should never be placed near or
over a radiator or heat register. This product should not be placed in a built-in
installation unless proper ventilation is provided.
7. This product should be operated only from the low voltage power provided
in your telephone line. No separate power supply is required.
8. Do not allow anything to rest on the telephone connection cord.
Do not locate this product where the cord will be abused by persons walking on it.
9. Do not overload telephone sockets as this can result in the risk of fire
or electric shock.
10. Never push objects of any kind into this product through base unit slots as they
may touch dangerous voltage points or short out parts that could result in a risk
of fire or electric shock. Never spill liquid of any kind on the product.
11. To reduce the risk of electric shock, do not disassemble this product, but take it to
qualified service personnel when service or repair work is required. Opening or
removing covers may expose you to dangerous voltages or other risks. Incorrect
reassembly can cause electric shock when the product is subsequently used.
12. Avoid using telephone equipment during an electrical storm. There may be
a remote risk of electric shock from lightning.
13. Do not use the telephone equipment to report a gas leak in the vicinity of the leak.
14. Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
a) When the power supply cord or plug is damaged or frayed.
b) If liquid has been spilled into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the operating instructions.
Adjust only those controls that are covered by the operating instructions because
improper adjustments of other controls may result in damage and will often
require extensive work by a qualified technician to restore the product to
normal operation.
e) If the product has been dropped or the base unit has been damaged.
f) If the product exhibits a distinct change in performance.
UK
D DK
E
F
I
N
NL
P
SF
S
8 X
UK
7
IMPORTANT SAFETY INFORMATION
PLEASE READ THE FOLLOWING INSTRUCTIONS BEFORE USE:
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product. The symbol
identifies and alerts the user to the presence of important operating and
service instructions.
3. Unplug this product from the telephone socket before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4. Do not locate base unit near water, for example, near a bathtub, wash bowl,
kitchen sink, or laundry tub, in a wet basement or near a swimming pool.
BASE FRONT
1 Headset Stand
2 On Line Indicator Light
3 Twelve Button Dial Pad
4 Flash Timing Switch
5 Headset Select Switch
6 Ringer Volume Control
7 Flash Button
8 Mute Indicator Light
9 Mute Button
10 Headset Socket
11 Headset Button
12 In-Use Indicator Light
13 Listen Volume Control
14 Redial Button
15 Tone Control
BASE REAR
16 Telephone Line Jack
17 Line Cable
HEADSET
18 Headset Cable
19 Clothing Clip
20 Adjustable Headband
21 Headset Assembly
22 Microphone Boom
23 Ear Loops (3 Sizes)
24 Pivot Ball Ring
25 Ear Cushion Assembly
DIAGRAM KEY