Paradyne CSU - Manual (Page 231)

7. Operation and Maintenance
9128-A2-GB20-80 September 2002 7-49
Type The method used to add the route to the table.
T RIP: The route was discovered through Routing Information
Protocol.
The route remains until its TTL (Time to Live) expires, a better
route is provided via RIP, or there is a power reset.
T Loc: The route was added due to the FrameSaver unit’s local
configuration; a Default IP Address or an SNMP Manager Initial
Route Destination have been configured.
The route remains until the unit’s configuration changes.
T NMS: The route was added by a Network Management System
using SNMP (Simple Network Management Protocol).
The route remains until there is a power reset of the unit.
T ICMP: The route was added because an ICMP (Internet Control
Management Protocol) redirect message was received from a
router indicating a better route to the destination. That is, a
datagram was sent to a router and the router is informing the
datagram source through an ICMP redirect message of a better
route.
T Tmp: The route was added as a temporary route in order to
respond to an IP packet that was received.
The route remains until its TTL expires or there is a power reset.
Interface Specifies the interface to be used to reach the destination.
T COM: Communications port
T PVC name : Name of the management PVC (e.g., PVCMgmt1001)
T Internal: The interface to be used for software loopbacks or internal
device functions in order to reach the destination.
TTL The Time to Live that was set for the route, in seconds: 1 – 999. If
999 appears, the route is a permanent one.
Table 7-15. IP Routing Table Values (2 of 2)
Column What It Indicates