PNY P-DSA150-PCI-RF User Manual
Page 14
Aug/07
MN2036400000
14
blank floppy disk then follow the directions below.
1.
Setup the RAID Array prior to Windows installation.
2.
Follow Windows® 2000 installation procedure.
3.
Restart the computer when prompted by the installation.
4.
At the Windows® 2000 Setup screen, press F6 to install the RAID
driver.
5.
When prompted, press S to specify the location of the driver.
6.
Insert the floppy disk, then press Enter.
7.
Select Silicon Image SiI 3x12 SATARAID Controller for
Windows NT 4.0 and 2000, then press Enter.
8.
Press Enter again to finish driver installation, then follow the
on-screen instructions to complete the Windows installation.
For An Existing Installation
1.
Setup the RAID Array prior to driver installation and boot up to
Windows.
2.
At Found New Hardware Wizard, click Next.
3.
Select Search for a suitable driver for my device (recommend)
then click Next.
4.
Insert the driver CD, check CD-ROM drives, uncheck the other
boxes, click Next, then click Next again.