Paradyne U8777 - Manual (Page 45)

8700-A2-GB20-40 May 2002 5-1
5
IP Addressing
Selecting an IP Addressing Scheme
Your IP addressing scheme depends in part whether the management card
controlling the chassis is running IP Conservative software.
Configurations Not Running IP Conservative Software
In a configuration not running IP Conservative software, the NTU’s network
interface IP address is assigned through the peer IP address of the LTU’s Network
Interface menu.
The termination unit is assigned an IP address and subnet through the DSLAM’s
Configuration
→
DSL Cards
→
Set IP Address menu. Once the address is
assigned, you can use the ATI to assign:
T Peer IP addresses to the DSL ports. These addresses are used as the IP
addresses of the remote units, and must be in the same subnet as the DSLAM
management card. See
Table A-1, Network Interface Options, in Appendix A,
Configuration Options.
T An IP address for each NMS to act as a trap manager. See Table A-15, SNMP
Traps Options, in Appendix A, Configuration Options.