Network interface options menu, Network interface options, Table a-1 – Paradyne U8777 User Manual
Page 98: Table a-1, network interface options, In appendix a, Configuration options, Menu
A. Configuration Options
A-2
May 2002
8700-A2-GB20-40
NOTE:
All changes to configuration options must be saved. Refer to
Initial Startup and Configuration.
Network Interface Options Menu
For Network Interface Options, refer to
Table A-1, Network Interface Options
. To
access the Network Interface Options screen, follow this menu selection
sequence:
Main Menu
→
Configuration
→
Current Configuration
→
Network
Table A-1.
Network Interface Options (1 of 4)
Port Status
Possible Settings: Enable, Disable
Default Setting: Enable
Determines whether the port can be configured and used.
Enable – The port can be configured and used.
Disable – The port cannot be configured or used.
Margin Threshold
Possible Settings: –5db, – 4db, – 3db, –2db, –1db, 0db, 1db, 2db, 3db, 4db, 5db,
6db, 7db, 8db, 9db, 10db
Default Setting: 0db
Determines the level, expressed in decibels, at which a signal-to-noise margin condition is
recognized.
– 5db to 10db – Sets the margin threshold to this value.
main/config/network
Slot: 18 Model: 87xx
Port 2
NETWORK INTERFACE OPTIONS
Port Status Enable
Margin Threshold: 0db
Excessive Error Rate Threshold: 1E–6
AutoRate: Disable
DSL Line Rate: 1552 Kbps
EIA-530 Payload Rate 1536 Kbps
Transmit Attenuation 0dB
Peer IP Address: 111.255.255.000 Clear
DS0 Cross Connect Line Framing: ESF
Circuit Identifier: Clear
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit
Save