Paradyne 6350-A4 - Manual (Page 8)

8
Status LEDs
All of the LEDs turn on and off during the power-on self-test. After a successful self-test,
the LEDs should appear as indicated in BOLD in the Condition column below.
Refer to Troubleshooting on page 9 for LED indications requiring action.
LED Condition Status
PWR ON ReachDSL modem has power.
ALM OFF
ON
No active alarms.
An alarm condition exists.
TST OFF
ON
No active tests.
The TST LED is on during the power-on self-test and
during a test initiated by the service provider.
LINE ON
OFF
The DSL link is active and ready to transmit and receive
data.
The DSL link has not been established.
TX/RX ON
OFF
Data transmission is in progress on the DSL line.
The modem is not transmitting or receiving data.
ETHERNET ON
OFF
The Ethernet connection to the Ethernet hub or PC is
active.
No Ethernet 10BaseT device is detected.