Panasonic NV-FJ620 - Manual (Page 7)

7
Example:
3 Press the MENU button U to finish the setting mode.
4 Retune your TV to the new RF channel for the VCR.
Note:
– Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.
To Change the RF output Channel
In some rare cases after tuning the TV to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.
Operations
1
Hold down MENU button U for 5 seconds or more.
– The VCR display changes as shown below and the
VCR picture on the TV displays this pattern.
2 Enter the desired channel number (AU28– 69, NZ21– 69)
by the Numeric buttons 2 or the Channel button N.
– Ensure that the VCR/TV switch E is set to [VCR].
– Set the RF output channel of the VCR to [ss] (RF OFF)
when the VCR is connected to the TV via the Audio/
Video cable.
Press the Channel button N to display [ss].
NV-FJ620A:
MENU
SELECT
END : , OK
:MENU
CLOCK SET
TUNER PRESET
CH ADD&DELETE
G-CODE CH SET
SYSTEM
OPTION
CH 1
CLEAR
[ OFF]
AUTO TUNE
SEARCH
[ 3]
FINE
END :MENU SELECT:
TUNER PRESET
CH 1 SEARCH
END: MENU
100
AUTO TUNING
IN PROGRESS,
PLEASE WAIT.
MENU
SELECT
END : , OK
:MENU
CLOCK SET
TUNER PRESET
CH ADD&DELETE
G-CODE CH SET
SYSTEM
OPTION
2 8 28:
UHF
28–69 0–12
VHF
NV-FJ620A 45–470MHz
21–69 1–11 NV-FJ620EA 45–470MHz
CATV
Panasonic VCR
END: MENU
Example for NV-FJ620A
VCR display
Example for NV-FJ620EA
On Screen Display
Auto Tuning Using the On Screen Display
Introduction
The VCR is tuned automatically by Plug in Auto Tuning.
However, Auto Tuning using the On Screen Display should
be performed according to the following method if necessary.
Preparations
– Confirm that the TV is on and the VCR viewing channel is
selected.
– Turn on the VCR and select any programme position
except A1 or A2.
– Set the VCR/TV switch E to [VCR].
Operations
1
Press the MENU button U to
display the Main menu on the TV
screen.
2 Press the Cursor buttons (34 34 34 34 34 ) S
to select [TUNER PRESET] then
press OK button T.
3 Press the Cursor buttons (34 34 34 34 34 ) S
to select [AUTO TUNE] then press
the Cursor buttons (21
21 21 21 21 ) S to start
the Auto Tuning.
– When Auto Tuning is completed,
the On Screen Display
disappears and programme
position 1 is selected.
The number displayed here
is the number of channels
still to be auto tuned.
Channels that can be Received
Notes:
– Auto Tuning searches for TV stations from VHF minimum to
UHF maximum and memorizes every tuned programme
position. Other programme positions are skipped.
– Auto Tuning takes five or more minutes to complete its
search.
– If the VCR is not correctly tuned by Auto Tuning, follow the
procedure on the next page.
28
ss
… 69
21
ss
69
(RF OFF)
NV-FJ620EA:
(RF OFF)