Panasonic VQT2T10 - Manual (Page 32)

32
VQT2T10
Volume (Channel balance) ( )
(Effective when playing multi-channel audio)
1
Select “Test” and press [OK].
A test signal is output.
2
While listening to the test signal
Press [ 3, 4] to adjust the volume of each
speaker.
The volume can be adjusted between r6 dB to s6 dB.
≥ Set each speaker level according to the volume of the
Front (L) and Front (R) speaker volume respectively.
≥ No signal is output for the subwoofer. To adjust its
volume, see page 18, “Adjusting speaker level during
play”.
3
Press [OK].
The test signal stops.
To finish the speaker setting
Press [
3, 4, 2, 1] to select “Complete” and press [OK].
O ptional speaker settin gs Speaker installation
option
You can attach all of the speakers (except subwoofer) to a
wall.
≥ The wall or pillar on which the speakers are to be attached
should be capable of supporting 10 kg (22 lbs) per screw.
Consult a qualified building contractor when attaching the
speakers to a wall. Improper attachment may result in
damage to the wall and speakers.
≥ Do not attempt to attach these speakers to walls using
methods other than those described in this manual.
1
Drive a screw (not included) into the wall.
A At least 30 mm (1 3 /
16
q)
B ‰ 4.0 mm ( 5 /
32
q)
C ‰ 7.0 mm to 9.4 mm ( 9 / 32
q to 3 / 8
q)
D Wall or pillar
E 5.5 mm to 7.5 mm (
7 /
32
q to 5 /
16
q)
2
Fit the speaker securely onto the screw(s)
with the hole(s).
Front speaker and surround speaker
Center speaker
F 100 mm (3 15 / 16
q)
Adjusting speaker level
A Center (C)
B Test
C Left Surround (LS), Right Surround (RS)
dB
0
0
0 0
0.0
0.0
ms
Complete
Test
LS
R L
RS
dB
dB dB
ms
C
0
dB
SW



Attaching to a wall






SC-BT228P_VQT2T10_eng.book 32 ページ ２００９年１２月６日 日曜日 午後４時３７分