Panasonic MC-V414 00 - Manual (Page 13)

MC-V414 00
13
3.7.2. Installation
1. Reinstall the motor protector into the dust compartment
by aligning the two tabs under the top flange with the slots
in the dust compartment by applying pressure from the
back of the vacuum until it snaps into place.
2. Install the dust cover by first ensuring all wiring is routed
correctly so that no wires may be pinched during assem-
bly.
NOTE: For general servicing, it is necessary to eliminate pinch-
ing of any wire during reassembly. After servicing any electrical
component or electrical enclosure, the unit should be reassem-
bled and checked for dielectric breakdown or current leakage.
3.8. Carbon Brush Replacement
3.8.1. Removal
1. Complete brush change on one side before starting on
the other side. There are two (2) brushes located on the
motor as identified. Remove the brush assembly by using
a Phillips head screwdriver to remove the screw that
holds the brush holder onto the motor.
NOTE: Do not drop screws into the motor.
3.8.2. Replacement
1. Place new brush assembly on the motor.
2. Make sure that the amp terminal on the bottom of the
brush assembly is inserted into the receptacle on the
motor.
3. Replace the Phillips screw that was removed.
4. Repeat steps 1-3 for the other brush assembly.