Pacific Digital MF-810 - Manual (Page 33)

Copyright© 2002-2003 Pacific Digital Corporation
Page 30
Important! To transfer slideshows from the Camera directly to your
MemoryFrame, you first need to prepare your MemoryFrame for
communicating, as described in the section below.
Preparing MemoryFrame to Communicate to Camera
The MemoryFrame cannot be managed or communicate with a camera
while it is displaying a slide show. In all cases, you must stop the
slideshow by pressing the Menu Button. This will place the
MemoryFrame in the Menu System mode that is required to
communicate with the Camera.
Important! Make sure that the camera’s memory-card is already
inserted into the camera before connecting the USB cable.
Next, connect the MemoryFrame directly to the USB digital camera
using the USB cable that was provided by the camera manufacturer (i.e.
the cable that came with your camera).
To use a camera, connect the “micro-USB” connector to the camera’s
USB port. Then connect the “Standard USB” connector to the “Camera”
connector of the MemoryFrame. See Figure 14.
Figure 14 – Connecting a Camera
The MemoryFrame is capable of displaying the pictures found in the
camera and allows you to download pictures from the camera directly