Panasonic WJ-FS309 - Manual (Page 17)

17
2. SPOT OUTPUT
2-1. AUTO SKIP
This item lets you enable or disable the Auto Skip function
to skip any steps where no video signal is present at the
Spot output.
Proceed as described in MULTI OUTPUT, 1.1 AUTO SKIP
on page 15.
3. MLT/SPT SEQ SETUP
This item lets you program or edit a Multi or a Spot
Sequence. Up to 9 (16) steps can be assigned in the SPOT
SEQ SETUP menu.
The duration of each step is also determined in the
MLT/SPT SEQ SETUP menu.
The initial factory setting is sequential display of 9 (16)
camera pictures.
■ System Setup Menu
Move the cursor to SYSTEM SETUP on the SETUP menu,
then press the
SET button. The SYSTEM SETUP 1/2 menu
appears on the monitor screen as shown below.
WJ-FS316 SETUP
ALARM SETUP
MONITOR OUTPUT SETUP
REC OUTPUT SETUP
SEQUENCE SETUP
SYSTEM SETUP
SYSTEM SETUP 1/2
TITLE SETUP
TITLE POSI
CAM SW LOSS ON
PLAYBACK AUTO ON
PASSWORD OFF
PWR ON MULTI QUAD-4A
PWR ON SPOT 1
COM. SETUP
SYSTEM SETUP 2/2
ENCODE PANA
SYSTEM SETUP 2/2
ENCODE OTHERS
SW INTERVAL 1
NO. OF CAMS 16
To go to SYSTEM SETUP 2/2, press the C button.
To go back to SYSTEM SETUP 1/2, press the D button.
1. TITLE SETUP
This item lets you edit the camera title to be displayed on
the monitor screen.
Up to 8 alphanumeric characters can be displayed on the
monitor.
1. Move the cursor to TITLE SETUP parameter, then press
the SET button.
The TITLE SETUP menu appears on the monitor screen
as shown on next page.
MLT/SPT SEQ SETUP
STEP CH SEC STEP CH SEC
1 1 2S 9 9 2S
2 2 2S 10 10 2S
3 3 2S 11 11 2S
4 4 2S 12 12 2S
5 5 2S 13 13 2S
6 6 2S 14 14 2S
7 7 2S 15 15 2S
8 8 2S 16 16 2S
MLT/SPT SEQ SETUP
STEP CH SEC STEP CH SEC
1 1 2S 9 9 2S
2 2 2S 10 -- 0S
3 3 2S 11 -- 0S
4 4 2S 12 -- 0S
5 5 2S 13 -- 0S
6 6 2S 14 -- 0S
7 7 2S 15 -- 0S
8 8 2S 16 -- 0S
<WJ-FS316/FS416>
<WJ-FS309/FS409>
Proceed as described in MULTI OUTPUT, 1.2 SEQ MODE
on page 16.