Panasonic WJ-FS309 - Manual (Page 14)

14
1. TITLE DISPLAY
This item lets you enable or disable recording of the cam-
era title with the picture.
1. Move the cursor to the TITLE DISPLAY parameter.
2. Select either ON or OFF.
The initial factory setting is ON.
ON: Enables recording of the camera title with the pic-
ture on the tape.
OFF: Disables recording of the camera title with the
picture on the tape.
■ Record Output Setup Menu
Move the cursor to REC OUTPUT SETUP on the SETUP
menu, then press the
SET button. The REC OUTPUT
SETUP menu appears on the monitor screen as shown
below.
WJ-FS316 SETUP
ALARM SETUP
MONITOR OUTPUT SETUP
REC OUTPUT SETUP
SEQUENCE SETUP
SYSTEM SETUP
REC OUTPUT SETUP
TITLE DISPLAY ON
REC MODE 004
1-3. BORDER
This item lets you select the color of the border that splits
the multiscreen output pictures in a Multiscreen display.
1. Move the cursor to the BORDER parameter.
2. Select the desired mode or color by pressing the
+ or –
button.
The initial factory setting for the border color is WHITE.
WHITE: White Border
GRAY: Gray Border
BLACK: Black Border
OFF: No border
1-4. QUAD SHIFT
This item lets you enable or disable the quad shift operation
when the
MULTISCREEN SELECT button is pressed on
the front panel. Quad shift displays a picture series such as
1-2-3-4, 5-6-7-8, 9-10-11-12 or 13-14-15-16 on quad
screens.(WJ-FS309/FS409 is only available 1-2-3-4 or 5-6-
7-8.)
1. Move the cursor to the QUAD SHIFT parameter.
2. Select ON or OFF by pressing the
+ or – button.
The initial factory setting is OFF.
ON: Enables the quad shift operation.
OFF: Disables the quad shift operation.
1-5. SECRET VIEW
This item lets you select whether to have the channel
selected for Spot output displayed as Multiscreen output.
1. Move the cursor to the SECRET VIEW parameter.
2. Select ON or OFF by pressing the
+ or – button.
The initial factory setting is OFF.
OFF: Disables Secret View. The same picture as dis-
played in Spot output is also displayed in Multi-
screen output.
ON: Enables Secret View: The channel of Spot that is
selected for SPOT OUTPUT, is displayed for black
picture in MULTISCREEN OUTPUT.
In case of the Spot Sequence mode, corresponding
picture is skipped.
2. SPOT OUT
2-1. TITLE DISP
This item lets you enable or disable the camera title display
overlaid on the spot output picture.
1. Move the cursor to the TITLE DISP parameter.
2. Select ON or OFF by pressing the
+ or – button.
The initial factory setting is ON.
ON: Enables display of the camera title.
OFF: Disables display of the camera title.