Panasonic WJ-FS309 - Manual (Page 19)

19
ON: Enables the PLAYBACK AUTO mode.
OFF: Disables the PLAYBACK AUTO mode.
5. PASSWORD
This item lets you select whether to permit free or limited
access to the Setup menus. When PASSWORD is set to
ON, the operator must enter the password to access the
menus.
1. Move the cursor to the PASSWORD parameter.
2. Select ON or OFF by pressing the
+ or – button.
The initial factory setting is OFF.
5-1. Password registration
Enter a 4-digit password consisting of numbers from 1 to 9
(except 0).
ON
→
1111-9999:
Password required to access the Setup menus.
1. Select ON by pressing the + or – button.
2. Move the cursor to the desired (first) digit by press-
ing the A or B button.
3. Select the desired number by pressing the + or –
button.
4. Repeat steps 2 and 3 until all digits are registered.
OFF: No password required to access the Setup
menus (access is free).
5-2. Reply to password request
If PASSWORD parameter is set to ON, the operator is
requested to type the password to access the Setup
menus.
1. Press the MENU/ESC button for 2 seconds or more.
The password inquiry screen prompts you to type the
password.
2. Type the 4-digit password by pressing the CAMERA
SELECT buttons 1 through 9, and the A or B button.
3. The Setup menu appears if the typed password is cor-
rect. If a wrong password is typed, the screen displays
“NG” and returns to the screen before the
MENU/ESC
button was pressed.
4. To retry repeat steps 1 and 2.
5-3. Changing the password
The password currently registered can be changed as fol-
lows.
1. Press the MENU/ESC button for 2 seconds or more to
display the password inquiry screen. Then type in the
current password by pressing the
CAMERA SELECT
buttons, and the A or B button. The SETUP menu
appears.
2. In the SYSTEM SETUP menu, select ON for the PASS-
WORD parameter.
3. Move the cursor to the first (desired) digit by pressing
the A or B button.
4. Select the desired number by pressing the + or – but-
ton.
5. Repeat step 3 and 4 until all digits are registered.
6. After registration the new password is required when
the operator accesses the SETUP menus.
6. PWR ON MULTI
This parameter lets you select a multiscreen output pattern
for your startup screen. When the power is turned on, the
picture is displayed in the selected pattern.
1. Move the cursor to the PWR ON MULTI parameter.
2. Select 1-16 (1-9 only for WJ-FS309/FS409), SPOT SEQ
or QUAD-4A to 4D, 9 screen, 16 screen, MLT-SEQ
The initial factory setting is QUAD-4A.
1-16: Spot picture of selected channel is displayed.
SPOT SEQ: A sequence of spot pictures is displayed.
QUAD-4A to 4D: 4-segment screen
9 screen: 9-segment screen
16 screen: 16-segment screen
MLT-SEQ: Multiscreen sequence
7. PWR ON SPOT
This parameter lets you select a Spot output pattern for
your startup screen. When the power is turned on, the pic-
ture is displayed in the selected pattern.
1. Move the cursor to the PWR ON SPOT parameter
2. Select 1-16 (1-9 only for WJ-FS309/FS409) or SPOT
SEQ.
The initial factory setting is 1.
1-16: Spot picture of selected channel is displayed.
SPOT SEQ: A sequence of spot pictures is displayed.