Pioneer CD-ROM DRIVE UNIT DR-U16S - Manual (Page 17)

17
<DRC1087>
En
CONNECTING THE DRIVE AS THE ONLY SCSI DEVICE
Pin 1
Power Cable
SCSI
Interface
Cable
Audio Cable
SCSI HOST
Adapter
Sound Board
To the power supply of
the personal computer
Into an expansion slot of
the personal computer
Fig.5
When no SCSI hard disk or other SCSI equipment is used, connect according to the following connection
method.
¶ Switch off the power supply of the personal computer.
¶ Set the SCSI ID number.
¶ Set the termination ON.
¶ Connect the power supply cable from the personal computer. At the time of connection, please
pay attention to the cable polarity.
¶ Connect the SCSI interface cable. At this time, confirm that the pin 1 of the SCSI connector is
connected correctly to pin 1 of the cable.
¶ When a sound board is used, connect the audio output with an audio cable to the sound board.
WARNING
The power supply of the personal computer always must be switched off before cables are
connected.