Panasonic PV-DF2703 - Manual (Page 31)

31
Timer Operation
Repeat steps 1 and 2 on page 30. 1
Press PROG twice to exit this mode.
2
3
To Clear program...
4
Press to select
the desired program.
1) Press SET to
display.
2) Press to
select and press
SET or
to set
new program
contents.
3) Press PROG.
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few
seconds to cancel the Timer
Recording.
• Any future daily or weekly recordings will
be performed as programmed.
Press ADD/DLT.
Review, Replace or Clear
Program Contents : (Recording
is not in progress)
• 2 minutes before Timer recording is performed, “PLEASE
PREPARE FOR TIMER REC” appears and/or the PROG
TIMER Indicator fl ashes. Be sure a cassette with record
tab is loaded and the unit is in Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up during a
normal recording or One Touch Recording (page 18), the
Timer Recording will not be performed.
• If there is a power interruption of more than one minute,
the recording may not be performed or continued.
• If “INCOMPLETE” appears after all items have been set,
check all entries and make necessary corrections.
*Important: I
f a remote control button does not work when pressed, press the button on the
remote and try the button again.
CANCEL : ADD / DLT
SELECT 1 - 8 :
ENTER : SET
END : PROG
8 SAT 9:00P 12: 00A 08
DATE START STOP CH
SELECT :
SET : SET
END : PROG
BACK :
SELE CT START DATE
TODAY
SLP
- - - - - - - - -- - - - - - - -- - - - - - -
P DT START STOP CH SPD
1 -- -- : -- -- : -- -- --
2 8 10 : 00p 12 : 00a 125 SP
3 10 8 : 00p 9 : 00p 10 SP
4 SU 9 : 00p 10 : 00p L LP
SELECT 1 - 8 :
ENTER : SET
END : PROG
To Replace program...
S U R R O
U N D
PROG
SELECT
SET
ADD/DLT
STOP
Notes