Panasonic SC-ZT2 - Manual (Page 8)

VQT2R70
8
Installation
Wireless functions
As this system uses a frequency band of 2.4 GHz, the radio waves may be interrupted by an obstacle. Depending on the
surrounding environment (i.e. radio wave interruption from outside, etc.) or the building structure where this system is used (i.e. wall
that easily refl ects radio waves, etc.), sounds may be cut or noise may occur.
Install this system properly paying attention to the following descriptions.
„ Equipment certifi cation
As this system received Technical Conditions compliance certifi cation based on the Radio Law, the wireless station license is not
required. However, if you do the following actions to this system, you may be held accountable by law.
• Disassemble or refurbish
„ Restrictions for use
• Domestic use only.
• Use this system in the same room.
„ Do not place an obstacle between the main unit and speakers.
Radio waves from this system reach a maximum range of 15 m (49 feet) in the same room. If there is an obstacle between the main
unit and speakers or the main unit is placed at the height of 50 cm (1.6 feet) or below from the fl oor, the radio waves reach a smaller
range.
„ Keep this system away from equipment that generates radio wave interference.
If the following equipment is located near the system, install this system away from such equipment.
• Bluetooth, OA devices, telephone, etc.: approx. 3 m (10 feet) or more.
• Microwave oven, wireless LAN compatible devices: approx. 3 m (10 feet) or more.
This system is designed to automatically avoid radio wave interference with such household equipment. If radio wave
interference occurs, the Wireless Link display (➜ page 14) may blink, the sounds from speakers may be interrupted or noise may
occur.
These phenomena occur when this system selects a proper frequency. These are not malfunctions.
„ Keep this system away from metal objects that tend to refl ect radio waves.
If there are metal objects or furniture in the room where this system is installed, radio waves tend to be refl ected. Depending on the
listening-viewing position, sounds may be interrupted or noise may occur. These symptoms may be remedied by slightly moving this
system’s position.
Note that radio waves tend to be refl ected also when this system is installed in rooms with a lot of activity.
„ There is no positional distinction for each speaker
before setting.
„ Make sure to place the speakers on a fl at, stable
surface so there is no danger of them falling over.
„ When carrying speakers, hold the pole and base
parts ( ➜ page 6).
„ The speakers of this system are not magnetically
shielded.
Do not install this system near a CRT-based
television.
Note
• Make sure the base parts are not covered by cloth such as a
curtain.
• Before attaching the leg cushion (included) on the base parts
to prevent tilt or rattle on the fl oor, make sure there are no
people in the surrounding area.
• If the main unit is placed at the height of 50 cm (1.6 feet) or
below from the fl oor, the radio waves reach a smaller range.
• Do not install other equipment directly on or under the main
unit.
Setup example
• Aim the front face (with Panasonic logo) of each
speaker at the listening-viewing position for setting.
Front speaker
(right)
Front speaker
(left)
Connected equipment
Main unit
Installation
Connection
5%<622
8364 'PKPFF 5%<622
8364 'PKPFF ඦ೨   ඦ೨