Panasonic AG-RT850P - Manual (Page 13)

13
TIME
TIME TIME
When the shift ( ) button is pressed, the hour
digits flash.
Press the SET (+, –) buttons to set the hour to “3”.
When the shift ( ) button is pressed, minute digits
flash.
Press the SET (+, –) buttons to set the minutes to
“25”.
t
y
[TIME ADJUST] P1
3-03-2001 SAT
3:00:00
[TIME ADJUST] P1
3-03-2001 SAT
3:25:00
When the MENU/REC LOCK switch is set to OFF,
the clock automatically starts running from time and
date set.
Flashing
For the seconds, “00” is set.
Even when the switch is set to MENU, the time will
keep advancing if it has not been changed.
u
3-03-01 48H
03:25:00
• To clear the date and time display, set POSITION under (DISPLAY) on Menu Screen 2 to OFF.
• Even if the power should fail for a period of up to one week, the date, time and other display time mode data are
stored in the memory (but only if power has been supplied continuously to the unit for 3 or more days).
When the unit has just been purchased or when it has not been used for along time, the data is not stored in the
memory and the display shown below appears.
[TIME ADJUST] P1
1-01-2000 SAT
0:00:00
• For the date setting, the unit automatically adjusts for leap years.
• Due to temperature fluctuations and other factors, the clock time may run fast or slow with a monthly error of up to
±60 seconds. This is not indicative of malfunctioning. Reset the time at regular intervals.
Time/Date Display Position
The position of the date and time displays on the TV monitor changes as shown below when (DISPLAY) on Menu
Screen 2 is changed.
Top left corner Top right corner Bottom left corner No display Center Bottom right corner
Set the MENU/REC LOCK switch to MENU to
display to menu screens. Press the page button to
display Menu Screen 2 on the TV monitor.
POSITION : L-UPPER
Press the set (+, –) buttons to position the display
as desired.
POSITION : L-BOTTOM
q
w
Upon completion of the settings, set the MENU/
REC LOCK switch to OFF. The regular screen is
restored, and the date and time appear at the
selected position.
e
TIME/DATE display position adjustment function
When the unit is in STOP or EJECT mode, the position of the displayed time/date can be adjusted by pressing the
TRACKING (–) or TRACKING (+) button.
• Pressing the TRACKING (–) button moves the position vertically. (Pressing the button 3 times will return the display
to its original position.)
• Pressing the TRACKING (+) button moves the position horizontally. (Pressing the button 3 times will return the
display to its original position.)
• Pressing the (–) and (+) buttons simultaneously will return the display to its original position (factory setting).
When the time is reset to “0:00:00” as described, check the menu
settings. If any of the settings are incorrect, please set them again.