Panasonic EY7840 - Manual (Page 6)

- 6 -
Service
1) Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of
power tool is maintained.
. SPECIFIC SAFE­
TY RULES
1) Wear ear protectors. Exposure to
noise can cause hearing loss.
2) Use auxiliary handles supplied
with the tool. Loss of control can
cause personal injury.
3) Hold power tools by insulated grip­
ping surfaces when performing an
operation where the cutting tool
may contact hidden wiring.
Contact with a “live” wire will make
exposed metal parts of the tool
“live” and shock the operator.
) Be aware that this tool is always in
an operating condition, since it does
not have to be plugged into an elec-
trical outlet.
5) If the bit becomes jammed, imme-
diately turn the trigger switch off
to prevent an overload which can
damage the battery pack or mo-
tor. Use reverse motion to loosen
jammed bits.
6) Do not operate the Forward/Reverse
lever when the trigger switch is on.
The battery will discharge rapidly
and damage to the unit may occur.
7) When storing or carrying the tool,
set the Forward/Reverse lever to
the center position (switch lock).
8) Do not strain the tool by holding
the speed control trigger halfway
(speed control mode) so that the
motor stops. The protection cir-
cuit will activate and may prevent
speed control operation. If this hap-
pens, release the speed control
trigger and squeeze again for nor-
mal operation.
9) Be careful not to get dust inside the
chuck.
10) Do not touch the rotating parts to
avoid injury.
11) Do not use the tool continuously for a
long period of time. Stop using the tool
from time to time to avoid temperature
rise and heat overload of the motor.
12) Do not drop the tool.
13) Do not put the tool on the place
where the chuck is depressed. The
bit may come off from the chuck
and fall down when the chuck is de-
pressed. It may cause injuries.
Symbol meaning
V Volts
Direct current
n
0
No load speed
… min -1
Revolutions or
reciprocation per minutes
Rotation with hammering
Rotation only
WARNING:
Some dust created by power sand-
ing, sawing, grinding, drilling, and
other construction activities con-
tains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemi-
cals are:
* Lead from lead-based paints
* Crystalline silica from bricks and
cement and other masonry prod-
ucts
* Arsenic and chromium from chem-
ically-treated lumber.
To reduce your exposure to these
chemicals: work in a well ventilated
area, and work with approved safe-
ty equipment, such as dust masks
that are specially designed to filter
the microscopic particles.
. FOR BATTERY
C H A R G E R &
BATTERY PACK
Important Safety Instructions
1) SAVE THESE INSTRUCTIONS
-
This manual contains important
safety and operating instructions
for battery charger .