PAC Ipac GM3 - Manual (Page 15)

17
For consumer technical support call:
714-835-3022 Hours: 8:00 AM - 4:30 PM, PST,MON- FRI
Within the first 12 months from date of purchase, subject to the conditions
above, Pacific Accessory Corporation will repair or replace the product
at their discretion, if it is defective in material or workmanship providing
it is returned to an Authorized Pacific Accessory Corporation’s Deal-
er, with PROOF OF PURCHASE from an authorized Pacific Accessory
Corporation dealer.
4.2 Warning:
This equipment may be reset by unintentional electrostatic discharge
during operation. Exposure to direct sunlight or extreme heat may cause
damage or malfunction.
4.3 FCC Class B Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
1. Reorientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that of
which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical
for help
Notice : The changes or modifications not expressly approved by the
party responsible for compliance could void the user authority to operate
the equipment.