PMI - Phoenix BIGSOUND P5 - Manual (Page 10)

Control Variables (DCC CV)
Versions of the P5 firmware after 1.00 support the following Control
Variables. These can be programmed on the program track or using
service mode programming.
OPS
MODE IS NOT CURRENTLY SUPPORTED
.
CV Description Default Value
1 Short Address 3
17 Long Address 0
18 Long Address 3
49 0 = Speed from Triggers; ≠ 0, speed from
DCC
0
50 The DCC Value where motion starts. 2
51 The DCC Rate (Speed vs. Throttle) 100
52 Seconds to simulate DCC if DCC signal is lost.
0 = Forever
0
53 Seconds in idle before shutdown.
0 = Never shutdown
0
February 2009
- 10 -