PLUS Vision U4-237 - Manual (Page 30)

E-30
General Operation
Enlargement of the Image and Video Movement
This function digitally enlarges the personal computer image and video
image.
(1) Press the ZOOM button to enlarge the image.
The zoom display appears when the ZOOM button is pressed.
When the ̆ button is pressed, the image is enlarged approximately 2
times, and when the
̄ button is pressed the image is reduced (re-
turning to 1:1).
• Images input from a Digital or PC card cannot be enlarged.
(No enlargement) (Approximately 2 times enlargement)
The image can also be moved in the following circumstances.
• When “Aspect” is set to “Real” by the signal of the Analog RGB, and the input resolution is higher than
the display resolution of the projector.
• When “Aspect” is set to “Zoom” by the video signal.
Note:
* Zoom and image movement functions are cancelled when the input is switched.
* Movement of the screen will not be possible when the menu screen is being displayed.
Zoom 0 Zoom 21
(3) Press the CANCEL button to immediately close the display.
The display will close when there has not been an operation in about
10 seconds.
(2) Pressing the SELECT
̆̄̇̈ buttons on the remote control at
the time of the zoom operation will cause the display position to
move.
(There will not be any movement when zoom is at 0.)
(Approximately 2 times enlargement) (Movement)
Zoom 21 Zoom 21
Note:
After magnifying the image, be sure to use the ZOOM button to bring the gauge
value back to “0”.
(3)
(1)
(2)
RGB
STANDBY
VIDEO
FREEZE MUTE ECO AUTO
ASPECT
TIMER VOL KSTN
CANCEL QUICK
MENU
ENTER
Q
1 2 3 4
ZOOM