Panasonic DVCPRO AJ-PCS060G - Manual (Page 27)

After clearing the error display ,
try formatting the card again. If
the error persists even after this,
contact the place of purchase.
The data format isn't standard.
After clearing the error display ,
you can resume use.
For further details about P2
cards, contact the place of
purchase.
12
13
An unusable P2 card has
been inserted.
After clearing the error display ,
restore a clip using a P2 camera-
recorder or other device before use.
There is a clip that needs to
be restored on the P2 card.
11
E-26
ENGLISH
ERROR LED display
Errors that may affect the unit are indicated as follows. Investigate the status and take these
corrective actions.
, , : LED lit , , : LED flashing
R : red OR : orange
REMAIN
R R
Status
The internal HDD temperature
is out of operating range.
Corrective Action
Turn the unit OFF and allow it to
cool down before use.
R R R
The unit is warming up when [E2]
flashes. Go to a warmer area.
R R The battery is low. Recharge the battery pack.
R R R R R The voltage is abnormally low.
Recharge the battery pack.
(Under these conditions, the unit
immediately shuts off.)
R R R
At the start of copying, there is
not enough HDD space.
After clearing the error display ,
format the internal HDD. If it
contains data you need, back up
the data on a different storage
media before formatting.
R R R
At the start of copying, a P2
card is not inserted. After clearing the error display ,
insert the P2 card, and copy.
R R R
At the start of copying, a
vibration occurred.
After clearing the error display ,
place the unit on a stable
surface.
After the vibration has stopped,
you can resume use.
R R R
At the start of copying, an
error other than insufficient
HDD space, a missing P2
card, vibration, and the like
has occurred.
R R
During copying, an error has
occurred. (Other than if the P2
card has been pulled out)
After clearing the error display ,
try copying the data again. If the
error recurs, switch P2 cards and
try copying again. If the error
persists even after this, contact
the place of purchase.
A formatting error has
occurred with the P2 card.
(Write-protected)
After clearing the error display ,
set the write-protect switch to the
opposite side from the
PROTECT position.
(See page E-14)
R R
1
2
3
4
5
6
7
8
9
10
No.
To clear the error display, press the [POWER] button and [CANCEL] button together.