Pioneer PureVision PDP-507XG - Manual (Page 38)

Useful adjustment settings 09
38
En
5 Press HOME MENU to exit the menu.
Note
• If you select "Auto", the selection for "Drive Mode" (see page 35)
becomes ineffective.
Sleep Timer
When the selected time elapses, the Sleep Timer automatically
places the system into the standby mode.
1 Press HOME MENU.
2 Select “Sleep Timer“ ( / then ENTER).
3 Select the desired time ( / then ENTER).
Select from "Off" (cancel), "30 min.", "60 min.", "90 min.", and "120
min.".
4 Press HOME MENU to exit the menu.
Note
• Five minutes before the selected time elapses, the remaining
time appears every minute.
• To check the remaining time, perform steps 1 and 2. After
checking the time, press HOME MENU to restore the previous
display.
• The SLEEP indicator on the front of the plasma display lights up
in orange when the Sleep Timer is set.
Using a password (AV mode only)
The plasma display provides a Child lock function for preventing
children from watching inappropriate programs. You need to enter
a password when watching programs with "Block" specified.
Before the system is shipped, "1234" is preset as the factory-default
password. You can however, change the password as you want.
You will need to enter the password before using the "Auto
Installation", "Analog TV Setup", or "Password" functions from the
Home Menu to prevent unauthorized changes to the settings.
Entering a password
In a case where you select a channel blocked with Child lock
function or if password entry is requested when attempting to open
the menu, enter a password correctly.
• Enter a correct 4-digit password using buttons 0 to 9.
Note
• If you fail password entry three times, "Invalid password."
appears, and the menu is closed. In order to display the
password entry screen again to unlock the password, select
the blocked channel or open the menu again.
• If the password entry screen disappears before entry, you may
recall it by pressing ENTER.
Changing the password
Use the following procedure to change the password.
1 Press HOME MENU.
2 Select “Setup“ ( / then ENTER).
3 Select “Password“ ( / then ENTER).
The password entry screen appears. Enter the current 4-digit
password using buttons
0 to 9.
4 Select “Change Password“ ( / then ENTER).
5 Enter a 4-digit password to be newly set, using the
buttons 0 to 9.
6 Enter the same password that you have entered in step 5.
• If a different password is entered, the operation goes back to
step 5 for reentry from the beginning.
• You can try up to three times to reconfirm the new password
before the Change Password screen is automatically exited.
7 Press HOME MENU to exit the menu.
Note
• Take a note of the newly set password and keep it handy.
Resetting the password function
1 Press HOME MENU.
2 Select “Setup“ ( / then ENTER).
3 Select “Password“ ( / then ENTER).
The password entry screen appears. Enter your 4-digit password
using buttons
0 to 9.
4 Select “Reset“ ( / then ENTER).
5 Select “Yes“ ( / then ENTER).
6 Press HOME MENU to exit the menu.
Note
• The above procedure will reset the password to the factory
default (1 2 3 4).
Please Input Your Password.
Change Password
Please Input New Password.
Reconfirm New Password.