Starting, Shutting down – Porter-Cable PCH3740 User Manual

Page 13

Advertising
background image

13- ENG

A08058

STARTING

Prior to starting, refer to your

engine manual for proper starting

procedure.
1. In a well ventilated outdoor area

add fresh, high quality, unleaded

gasoline with a pump octane

rating of 86 or higher. Do not

overfill. Wipe up spilled fuel before

starting the engine. Refer to

Engine Owners Manual for correct

procedure.

2. Check engine oil level. See

Engine Owners Manual for correct

procedure.

NOTE: There will

be a slight amount of oil in the

engine from factory testing.

3. Verify the filter

screen is in

water inlet of

pump.

NOTE:

Cone side

faces out.

4. Connect water source to pump

inlet.

NOTE: Water source must

provide a minimum of 5 gallons per

minute at 20 PSI.

5. Connect high pressure hose to

pump outlet.

6. If applying a chemical or

cleaning solution, see How

To Apply Chemicals/Cleaning

Solvents instructions in this

section.

7. Turn water source on.

NOTE: Failure to do so could

cause damage to the pump.

8. Start engine. See Engine

Owners Manual for correct

procedure.

NOTE: When engine

rope is pulled, pressure starts

building in the gun. If the engine

does not start after two pulls,

pull the gun trigger to relieve this

pressure.

9. Depress trigger on gun to

start water flow. NOTE: Stand

on a stable surface and grip

gun/spray wand firmly with both

hands. Expect the gun to kick

when triggered.

10. Release trigger to stop water

flow.

11. Adjust spray for the task being

performed by changing quick

connect nozzle. See How To Use

Spray Wand instructions in this

section.

SHUTTING DOWN

1. After each use, if you have

applied chemicals, place chemical

hose into container of clean water

and draw clean water through

chemical injection system to rinse

system thoroughly.

NOTE: Failure

to do so could cause damage to

the pump.

2. Turn engine off. See Engine

Owner’s Manual.

NOTE: NEVER

turn the water off with the engine

running.

3. Turn water source off.
4. Pull trigger on spray gun
to

relieve any water pressure in

hose or spray gun.

5. See Storage section in this

manual for proper storage

procedures.

Filter Screen

High Pressure Hose

Water

Source

Advertising
This manual is related to the following products: