Porter-Cable PCH3740 - Manual (Page 8)

8- ENG A08058
5. Connect wand to gun. Tighten
securely.
4. Attach high
pressure hose
to gun. Tighten
securely.
6. Place the nozzle holder onto
the panel (located on the handle
assembly) and push each nozzle
holder into place.
7. Remove five colored quick
connect nozzles from plastic
bag and insert them into correct
grommet on the nozzle holder.
NOTE: Nozzles are color coded
to match colored nozzles on
panel.
The shipping plug
must be removed
and replaced with the dipstick/oil
plug before operating pressure
washer.
10. Using a 7/8"
wrench, remove
shipping plug from
pump by turning it
counterclockwise.
Discard plug.
11. Remove dipstick/oil plug from
plastic bag and install into pump,
tighten securely.
NOTE: The high pressure pump was
filled with oil at the factory. There is no
need to add oil at this time, see the
Maintenance section of this manual
for Maintenance information.
8. Slide the formed rubber covers
onto the handle's on-board hose
and wand storage.
9. Add engine oil (supplied)
to engine. Refer to Engine
Owners Manual supplied by
engine manufacturer for correct
procedure.
NOTE: There will be a slight amount
of oil in the engine from factory
testing.