Panasonic DP-C213 - Manual (Page 88)

88
Cha
pter 6 Printer S
etting
s
15 - 29 20 AppleTalk Printer Name Set the AppleTalk printer
name.
z When the optional Printer
Controller Module (for Adobe
®
PostScript ® 3 ™ ) is installed.
There is no default value. When
the machine starts up under the
following parameter settings "18
Apple Talk" is set to "On", "19
AppleTalk Zone Name", and
"20 AppleTalk Printer Name"
are not set, then, “Panasonic
DP-XXXX and the lower six
figures of MAC Address” will be
automatically setup.
Up to 31 characters Panasonic
DP-XXXX-
the lower
six figures
of MAC
Address
21 AppleTalk Type Name The machine detects, and
display the AppleTalk Type
Name on the Touch Panel.
z The Apple Talk Type Name is
displayed only, but cannot be
set.
z When the optional Printer
Controller Module (for Adobe
®
PostScript ® 3 ™ ) is installed.
22 NetWare Set “On” to use NetWare. Off, On Off
23 NetWare Frame Type Set the NetWare frame type. 802.3, 802.2, Ether-II,
SNAP 802.2
24 Selected Frame Type The machine detects, and
display the Frame Type on the
Touch Panel.
z Frame Type is displayed only,
but cannot be set.
25 NetWare Mode Select NetWare Mode.
• Pserver
The machine is used as Print
Server, and prints the waiting
job stored in the machine.
• Rprinter
The machine is used as
Remote Printer, and prints
data which is sent from the
Print Server.
Pserver, Rprinter Pserver
26 NetWare Printer Name Set the NetWare printer name. Up to 31 characters
27 Print Server Name Set the print server name. Up to 31 characters
28 Print Server Password Set the print server password. Up to 31 characters
No. 20 to 23, 25, to 28
After setting any of these parameters, turn the
machine’s power switch Off, and then On again.
Key Operator
No. Parameter Comments Selective Item Standard
Setting