Piaggio 250 i.e. - Manual (Page 37)

A running engine automatically switches off when the ignition cut-off switch is set to
OFF.
The scooter is equipped with automatic transmission with direct drive, so that starting is
effected by turning the throttle grip to idle speed; to start-off from still, progressively twist
the throttle grip. The vehicle is equipped with an electrical fuel pump that switches on
automatically as soon as the engine is started. To start the vehicle, before pressing the
starter button «B», pull and keep pulled the front brake lever «D» or the rear brake lever
«G» that operates the corresponding ignition consent switches. Besides, if the vehicle has
a front suspension locking system, a sensor placed under the saddle will prevent vehicle
motion, but not ignition, if the rider is not seated in riding position.
1. Rest the vehicle on its centre-stand, ensuring the rear wheel is not touching the ground.
2. Maintain the throttle "C" completely untwisted.
3. Insert the key into the ignition switch "A" and turn it onto the ON position.
4. Make sure that the "I" switch is set onto the ON position.
5. Pull either the front, "D", or rear brake lever, "G", while pressing the starter button "B".
WARNING
THE AUTOMATIC TRANSMISSION MAKES THE REAR WHEEL TURN EVEN WHEN
THE THROTTLE IS SLIGHTLY TWISTED. RELEASE THE BRAKE CAREFULLY AF-
TER STARTING, AND THEN ACCELERATE GRADUALLY.
CAUTION
DO NOT START-UP THE ENGINE IN CLOSED AREAS BECAUSE EXHAUST GASES
ARE TOXIC.
37
2 Use