Panasonic KX-TG5671 - Manual (Page 11)

Preparation
For assistance, please visit http://www.panasonic.com/phonehelp 11
Setting up the base unit
Connecting the AC adaptor and
telephone line cord
Connect the telephone line cord until it
clicks into the base unit (
A) and telephone
line jack ( B). Connect the AC adaptor cord
by pressing the plug firmly ( C).
L Use only the included Panasonic AC
adaptor PQLV1 or PQLV256.
Note:
L
The AC adaptor must remain connected
at all times. (It is normal for the adaptor
to feel warm during use.)
L The AC adaptor should be connected to
a vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to
a ceiling-mounted AC outlet, as the
weight of the adaptor may cause it to
become disconnected.
L The unit will not work during a power
failure. We recommend connecting a
standard telephone to the same
telephone line or to the same telephone
jack using a Panasonic T-adaptor (page
7). Emergency power can be supplied to
the unit by connecting a Panasonic
battery back-up power supply noted on
page 7.
If you subscribe to a DSL service
Please attach a noise filter (contact your
DSL provider) to the telephone line
between the base unit and the telephone
line jack in the event of the following:
– Noise is heard during conversations.
– Caller ID features (page 28) do not
function properly.
Hook
(120 V AC,
60 Hz)
To single-line
telephone jack
(RJ11C)
A
B
C
Noise filter
To single-line
telephone
jack (RJ11C)
TG5671_72_73(e).book Page 11 Wednesday, January 11, 2006 7:03 PM