Panasonic EW3111 - Manual (Page 9)

16 15
Troubleshooting
The “E” blinks
on the display
Display Status before error
Pressurization to above
300 mmH
g was
performed.
(Re-pressurization was
performed several times.)
Pressure decreased
suddenly and “E”
appeared in the display.
The measurement
process was performed
until 20 mmH
g was
reached and then “E”
appeared in the display.
Pressurization to above
180 mmH
g was not
performed.
Check points
Check whether measure-
ments are being taken
correctly and whether the
user is assuming the
correct posture.
Make sure the cuff is
correctly attached to your
upper arm.
(See pages 10 and 11)
Check whether the
pressure cuff is attached
to your upper arm
correctly.
Make sure the tube is fully
inserted into its socket.
(See pages 7 and 10)
1. Loosely roll up the cuff and place it
in the cuff holder.
2. Put the tube inside the cuff.
• Do not wrap the tube around the
unit, etc. Excessive straining of the
tube can cause malfunctioning.
Storage