Panasonic TC 15DT2 - Manual (Page 51)

51
To enjoy program repeat play
If REPEAT MODE is pressed during program play (see page
52), the display changes as follows:
To return to program play
Press REPEAT MODE until “ OFF ” is displayed.
Program play
Repeat of programmed track
being played
Repeat of all programs
Cancel repeat mode
(Program play)
T PRG
A PRG
OFF OFF PRG
A A •
2
Press A-B REPEAT at the point where
repeat play is to be concluded (B).
A B A B
Repeat play of the section between points A and B starts.
To return to normal play
Press A-B REPEAT until “ • • ” is displayed.
Note
• A-B repeat play does not work with an interactive DVD.
• Some subtitles recorded around point A or B may fail to appear
(DVD).
• A-B repeat play works only within a title (DVD) or a track (Video
CD/CD).
For your reference:
• The end of a track or title is automatically determined as point B.
∗ ∗
1 2 3 4
Storing markers in memory to be
viewed (listened to) again
Repeating sections between two
specific points ( A-B repeat )
1
Press A-B REPEAT during play at the point
where repeat play is to start (A).
Note
• Some subtitles recorded around the marker may fail to appear. [DVD]
• These operations do not work with an interactive DVD or during
menu play of a Video CD with playback control.
For your reference:
• All the markers are cleared when the player is set to the standby
mode or turned off, or OPEN CLOSE is pressed.
4
Press SELECT ( ) button to recall a marker.
or
Press CANCEL to clear a marker.
Play resumes from the point corresponding to the selected marker.
or
The selected marker is cleared.
∗ ∗
1 2 3 4
3
Press SELECT ( , ) button to select the
marker to be recalled/cleared.
1
Press the DISPLAY during play to display
the Disk information.
2
Recalling / clearing a marker
Press SELECT ( , ) button to select the
marker item.
• Press select ( ) key and press ENTER to store the next marker.
• Up to 5 markers can be stored in the memory.
• Press MARKER to clear the display.
∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
1
Indicates “MARK 1” is stored in the
memory.
(If ENTER is pressed where any
number is already displayed, the
previous starting point will be
replaced by the new one.)
3 Press SELECT during play at the starting
point to be viewed (listened to) again.
2
Press SELECT ( , ) button to select the marker item.
The marker screen appears
on the TV monitor.
“ ” indicates no marker has
been stored yet.
1
Press the DISPLAY during play to display
the Disk information.
Storing a marker in the memory
∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗