Removing the front panel 8, Attaching the front panel 8, Resetting the microprocessor – Pioneer DEH-P85BT User Manual

Page 8: About the demo mode, Before you start, Removing the front panel, Attaching the front panel

Advertising
background image

! You can turn off the warning tone. See

Switching the warning tone on page 49.

! You can turn off the face auto open. See

Switching the face auto open on page 49.

Important

! Handle gently when removing or attaching

the front panel.

! Avoid subjecting the front panel to excessive

shocks.

! Keep the front panel out of direct sunlight and

high temperatures.

! A few seconds after turning the ignition

switch to on or off, the front panel automati-
cally moves. When this happens, your fingers
may become jammed in the panel, so keep
your hands away from it.

Removing the front panel

1

Press and hold OPEN to open the front

panel.

2

Slide and remove the front panel to-

ward you.
Take care not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.

3

Put the front panel into provided pro-

tective case for safe keeping.

Attaching the front panel

1

Make sure the inner cover is closed.

2

Replace the front panel by clipping it

into place.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time

after installation

! If the unit fails to operate properly

! When strange or incorrect messages ap-

pear on the display

% Press RESET with a pen tip or other
pointed instrument.

RESET button

About the demo mode

This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.

Before You Start

En

8

Section

01

Advertising