PYLE Audio PLD43MU - Manual (Page 20)

Radio Operation
1 2 3 MOD
6 4 5 BND
ST DX DISC-IN
CH
6
SWF POP 11:08 AM
FM1 98.10
MHZ
Setting Memory
Press the /CH 1-6 button repeatedly
on the front panel to preset stations at
radio mode .
Or touch the screen the
1 / 2 / 3 / 4 / 5 / 6 sections
(
)
Touch to preset station
With this system, a total of 30 stations
can be stored in the memory of six
buttons. Each band stores up to six
preset stations. The stations might be
FM1, FM2, FM3, AM1(MW1), and
AM2(MW2) band.
The operation is as below :
Touch the BND section on the
touch screen repeatedly to
select the band , screen band
will show in turn :
Selecting The Frequency Band
FM1 FM2 FM3
AM2(MW2) AM1(MW1)
BND
You can also press the BND on front
panel repeatedly to select the band .
(
)
19
Repeatedly Touch the MOD
section on the touch screen to
select the RADIO mode.
(You can press the MOD button
on front panel to select the
Radio mode .)
Switching To Radio Mode
MOD
the following information will appears on
the monitor :
1 2 3 MOD
6 4 5 BND
FM1 87.5
MHZ
ST DX DISC-IN
CH 6
SWF POP 11:08 AM
Listening to the Radio
Storing Stations In Memory
-Retrieve a preset station
Touch the 1-6 sections briefly (or press
the /CH1-6 button repeatedly) to
retrieve a station which had been stored
in the memory in advance the chose
number is shown on display .
Start Searching For a Station
Manual Search
Touch briefly the “ ” section on
the screen (or swing briefly the
SEL knob in
direction) to
increase frequency by one step
of channel spacing .
Touch briefly the “ ” section on
the screen (or swing briefly the
SEL knob in
direction) to
decrease frequency by one step
of channel spacing .
-Store in Memory
Touch and keep the 1-6 sections
(or press and hold the
/CH 1-6) for
about 2 seconds, the current listening
station will be stored into the
number location
.
Automatic Search
During Radio mode, swing and hold
(for about 2 seconds )the SELknob in
/ direction (or touch the /
section long) to start search for a radio
station automatically .