Precision Power A1000/2 - Manual (Page 14)

FRONT PLATE DIAGRAM
1. Cooling Plenums: Maintain a minimum 2” clearance around
cooling plenums for proper amplifier cooling.
2. Speaker/Remote Connector: The
PowerLock TM speaker
connector.
3. Output Xover Freq. Control: Use this control to adjust the sub
bass output signal crossover frequency from 30Hz to 4kHz. (See the
Crossover Frequency chart in this manual).
4. Output Xover FULL/LP/HP Switch: Select the desired crossover
setting HP/LP/FULL for the signal of the RCA outputs.
5. QBASS
TM Freq.: Use this switch to set the QBASS TM frequency
(applicable to model A800/2 and A1000/2, refer to QBass
Plus/QBass Remote section).
6.-12dB Input Attenuation: Push this switch ‘IN’ for high voltage
(4V-12V) capability. This button pushed ‘IN’ must be used for
speaker level input on common ground head-units or for high
voltage line drivers.
7. Gain: Use this control to match the output level of the source unit
to the amplifier.
8. Input: Plug in the RCA leads from your source here.
9. Xover Adjustment: Adjusts the crossover between 30Hz and 4kHz.
10. Xover FULL/LP/HP Switch: Select the desired crossover
setting FULL/LP/HP.
11. QBass: Use this switch to set the
QBASS TM frequency
(applicable to model A800/2 and A1000/2). On the A500/2 this is the
R
L
BRIDGE
- +
R- R+ REM L+ L-
LP
OUTPUT XOVER
OUTPUT FREQ FULL HP 2 1 -12dB
MIN MAX
FREQ QBASS ATT
GAIN
R
L
INTPUT FREQ FULL HP
XOVER
30 40k
LP
30 40k
1 2 3 4 5 6 7 8 9 10
11 12
13