2 product description – Porter-Cable DSR2210 User Manual
Page 40
2 Product description
2.1 Front view
1
Stand-by button:
Switch receiver ON or Standby.
Reset the receiver, in case of hanging up, after a 5 second keypress.
2
OK button:
Button to confirm your selection.
3
Smart card reader.
4
"W" button:
Channel down.
5
Red LED indicator:
Is lit whenever the receive is in stand-by mode (*).
6
“V” button:
Channel up.
(*): Note: if the LED is slowly blinking, it indicates that a free over the air upgrade of your receiver is taking
place. Do not interrupt this operation which may last several minutes. Wait until the LED stops blinking.
The LED blinks rapidly when receiving remote control signal.
When the receiver is operating, the LED is turned off. To check whether the receiver is properly powered,
remove the power plug and plug it back in. The front panel LED will blink once.
English
4 PRODUCT DESCRIPTION
3
4
5
6
1
2