Planet Technology 1-Bay SATA NAS Server NAS-7100 - Manual (Page 5)


HDD Install/Remove
The.NAS-7100.supports.one.3.5-inch.Serial-ATA.(SATA).hard.drive..NAS-7100.does.
not support low profile or half high hard drive.
HDD Install
1..Make.sure.the.NAS-7100.is.powered.off
2..Open.top.cover.of.NAS-7100
3..Make.sure.your.hard.drive.is.SATA.interface.and.make.sure.you.back.up.all.pre-
existing.data.before.use.it.on.NAS-7100
4..Pull.up.the.HDD.tray.then.slide.and.push.the.HDD.into.the.tray,.make.sure.con-
nector.well.connecting
5..Push.down.the.HDD.tray
6. Put the top cover of NAS-7100 back to finish HDD install
HDD Remove
1..Make.sure.the.NAS-7100.is.power.off.
2..Open.top.cover.of.NAS-7100
3..Pull.up.the.HDD.tray,
4..Pull.out.the.HDD.till.SATA.connector.release.then.the.HDD.can.slide.out.of.HDD.
tray