Planet Technology 1-Bay SATA NAS Server NAS-7100 - Manual (Page 6)


System Installation
Boot up
1..Connect. the. network. cable. to. LAN. port. on. the. rear. of. NAS-7100.. Connect. the.
others.end.to.your.hub.or.switch.
2..Connect. the. supplied. power. adapter. to. a. power. outlet. and. plug. the. power. cord.
into.NAS-7100’s.power.input.on.the.rear.panel.
3..Power.on.
. Locate. the. NAS-7100’s. power. switch. on. the. NAS-7100. real. panel.. Press. it. once.
to.power.on.the.NAS
4..The.NAS-7100.self-test.
. The. NAS-7100. will. run. a. brief. self-test.. During. the. self-test,. all. of. NAS-7100’s.
LED will be illuminated or flashing.
5..Booting.up.
. When.the.self-test.is.complete,.boot.up.will.start..The.Ready.LED.will.blink.con-
tinuously,. and. the. LAN. LED. will. blink. occasionally.. Boot. up. should. take. approxi-
mately.1-3.minutes.
6..Boot.up.completed.
. When.the.Ready.LED.stops.blinking,.and.remains.on,.boot.up.is.complete..If.the.
Status. (Orange). LED. stays. on,. or. if. the. NAS-7100. repeatedly. beeps,. there. is.
a. hardware. problem.. Consult. the. Troubleshooting. section. of. the. User. Guide. for.
possible.solutions.
Shutdown
To. shutdown. the. NAS-7100,. press. the. power. switch. to. start. the. shutdown.
sequence..Wait.for.all.LEDs.to.turn.off.
Removing a USB device
1..Press.the.USB.eject.button.(for.USB.1.or.2).on.the.rear.panel.
2..Wait.for.the."USB".LED.turn.off.
3..Remove.the.USB.device.
You.can.also.use.the.Windows.utility.installed.from.the.CD-ROM:
1..Select.“Safely.Remove.USB.Device".
2..Select.the.desired.NAS.and.USB.device,.and.click.the."Eject".button.
3..Wait.for.the.message.telling.you.it.is.safe.to.remove.the.USB.device.
Note
If. the. USB. device. is. not. removed,. it. will. not. be. re-connected.. You.
must.remove.and.re-insert.the.USB.device.to.have.it.re-connected.