Panasonic LSQT0676A - Manual (Page 56)

56 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Output Balance Setup
1
Adjust the volume level output from the speakers. To adjust, play a disc or set the “TEST SIGNAL”
(p.57) to ON. Then adjust while confirming the volume. (Even if “OFF” or "NONE" is set in “SPEAKER
SIZE,” the speaker OUTPUT BALANCE can still be set.)
2
Settings for DVD Operation (continued)
Delay Time Setup
1
To enjoy 5.1 CH sound, it is ideal to place all
speakers, except the subwoofer, in a circular
arrangement. (See <Speaker Position> p. 57.)
If this is not possible, setting Delay Time gives the
sound output a delayed effect which gives you the
illusion of the ideal listening position. (See right.)
2
3
Press ACTION three times to exit.
Press
to select “OUTPUT BALANCE,” and press
SET
to display OUTPUT BALANCE screen.
Press
to select an item, and press
SET repeatedly.
(See below table.)
Press
to select “DELAY TIME,” and press
SET
to display DELAY TIME screen.
Press
to select an item, and press
SET
repeatedly. (See below.)
OUTPUT BALANCE
SELECT :
SET : SET
END : ACT I ON
CENTER CENTER : 0dB : 0dB
SURROUND(R) : 0dB
SURROUND(L) : 0dB
SUBWOOFER : 0dB
TEST SIGNAL : OFF
Menu item
SURROUND
CENTER
Remark Setting
0ms 1ms 2ms 3ms 4ms 5ms
0ms(Factory preset)
Setting a delay effect.
0ms 5ms 10ms 15ms 20ms
Distance Setting B1
Approx. 50 cm (1 feet) 1/2
Approx. 100 cm (3 feet)
1.3 ms
2.6 ms
3.9 ms
5.3 ms
Approx. 150 cm (5 feet)
Approx. 200 cm (6 feet)
C1 Distance Setting
Approx. 200 cm (6 feet)
Approx. 400 cm (12 feet)
5.3 ms
10.6 ms
15.9 ms Approx. 600 cm (18 feet)
B1 Center speaker
C1 Surround speaker
• , : Delay time as 0ms
(Factory prest)
• , < : Find the distance B1 , C1 in the
table (below) and change to
the recommended setting.
[See <Speaker Position> p.57.]
3
Press ACTION four times to exit.
Menu item
SUBWOOFER
SURROUND(L)
SURROUND(R)
CENTER
Remark Setting
-6dB ~ +6dB
0dB(factory preset)
Adjust so that the center speaker volume is virtually the same
level (-6dB ~ +6dB) as the front speakers.
Adjust so that the surround speaker(R) volume is virtually
the same level (-6dB ~ +6dB) as the front speakers.
Adjust so that the surround speaker(L) volume is virtually
the same level (-6dB ~ +6dB) as the front speakers.
Adjust so that the subwoofer speaker volume is optimum.
However, because no test sound will come from the
subwoofer, play a disc to confirm, then adjust.
TEST SIGNAL : Switch test signal used for OUTPUT BALANCE setting to “OFF” or “FRONT(L)”....
➡ See page 57.
Do steps 1~2 of “Speaker Output Setup” on page 55.
Do steps 1~2 of “Speaker Output
Setup” on page 55.
2 D4763S P36-60 (030512 –§”Ф•П•X2nd).p65 2003/05/14, 13:47 56