PYLE Audio PLCD19XMR - Manual (Page 13)

13
OPERATION
RADIO OPERATION
SWITCHING TO RADIO MODE
Press MODE button (6) shortly to select
radio mode, the radio mode appears in
the display together with the memory
band and frequency.
SELECTING THE FREQUENCY BAND
At radio mode, press BAND/ENTER
button (18) shortly to select the desired
band.
The reception band will change in the
following order:
SELECTING STATION
Press CH button (16) or CH button
(17) shortly to activate automatic seek
function. Press for more than 3 seconds
until “MANUAL” appears on the display,
the manual tuning mode is selected.
If both buttons have not been pressed for
several seconds, they will return to seek
tuning mode and “AUTO” appears on the
display.
AUTOMATIC MEMORY STORING &
PRSET SCAN
- Automatic memory storing
Press AS/PS button (2) for serveral
seconds, the radio searches from the
current frequency and checks the signal
strength until one cycle search is
finished. And then 10 strongest stations
are stored into the corresponding preset
number button
- Preset Scan
Press AS/PS button (2) shortly to scan
all station presets saved in memory.
STATION STORING
The preset buttons (14) can be used to
store 10 stations in each band (FM 1, FM
2, FM 3 and AM1, AM2) for convenient
access to your favorite stations.
- Programming stations
1. Select the desired band, then tune
in the station you want to store in
memory.
2. Press and hold one of the preset
buttons (14) for more than 2 seconds
until the corresponding preset button
number appears. Repeat steps 1 and
2 to program additional stations.
- Quick tuning
Select the desired band, then press one
of the ten preset buttons (14).
SCAN
Press SHIFT/SCAN button (13) to set
function to scan mode, which scanning
to higher frequency station with receivable
signal and keep on each station for several
seconds.
XM OPERATION
SWITCHING TO XM MODE
Shortly press MODE button to select XM
mode.
SELECTING USER-PRESET CHANNEL
In XM mode, the XM user-preset channel
group is toggled cyclically through the
group by quickly pressing the BAND
button.
The channel will change in the following
order:
SELECTING CHANNEL UP/DOWN
Press the CH / buttons to select the
channel up or down.
SEARCHING SCHANNEL
When the AS/PS button is shortly pressed,
the unit searches for each user preset
channel from XM1 , XM2 to XM3. When
an available channel is detected, the
channel will be held at that preset number
and played about 5 seconds. After that,
it will search for another available channel.
DIAGNOSTIC MODE
Press and hold AS/PS button for over 5
seconds will enter diagnostic mode and
display “STATE1”, then press channel
UP/DOWN key to select each state as
below:
->STATE1->STATE2->STATE3->STATE4
->STATE5->STATE6->STATE7-> STATE8
->STATE9
Short press AS/PS button will exit
diagnostic mode.
FM1 FM2 FM3 AM1 AM2
XM1 XM2 XM3