For your safety read before lighting – PB Heat DE User Manual

Page 26

Advertising
background image

24

START-UP PROCEDURES

Figure 7.3:

Operating Instructions

SV9501/SV9601 9318 REV 2 (MM/YY)

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury, or loss of life.

OPERATING INSTRUCTIONS

TO TURN OFF GAS TO APPLIANCE

1. Set the thermostat or operating control to lowest
setting.

2. Turn off all electric power to the appliance if service is
to be performed.

3. If the gas valve is not visible, remove the control access
access panel.

4. Slide the gas control switch to "OFF".

5. Replace control access panel, if applicable.

1. STOP! Read the safety information above on this
label.

2. Set the thermostat or operating control to lowest
setting.

3. Turn off all electric power to the appliance.

4. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to light
the pilot by hand.

5. If the gas valve is not visible, remove control access
panel.

6. If the gas control switch is not in the "OFF" postion,
slide the switch to "OFF".

7. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.

8. Slide the gas control switch to "ON".

9. Replace control access panel, if applicable.

10. Turn on all electrical power to the appliance.

11. Set thermostat or operating control to desired setting.

12. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance"
and call your service technician or gas supplier.

A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.

B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance

Do not touch any electric switch;
do not use any phone in your building.

Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.

If you cannot reach your gas supplier,
call the fire department.

C. Use only your hand to slide the gas control switch
Never use tools. If the witch will not slide by hand,
don't try to repair it, call a qualified service technician.
Force or attempted repair may result in a fire or
explosion.

D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.

Advertising