Panasonic WV-NS324 - Manual (Page 9)

Note: All DIP switches except SW1 and SW2 should
always be set to "off".
3. Assemble the Camera
Reverse the disassembly procedure. Take care not
to cut any cables.
Precaution
Be sure to select a ceiling board strong enough to sup-
port 4 times the total weight of the camera.
a. Sideway Cable Exit
Prepare a cutout in the diecast case and decora-
tion cover as shown in the following figures.
Cutout in Diecast Case
Status No.
-9-
INSTALLATION
Precautions
• The following installation and connection work
should be done by qualified service personnel or
system installers and should conform to all local
codes.
• Be sure to switch the camera off before installation
and connection.
• Do not install the camera near the air outlet of an
air conditioner.
1. Disassembling the Camera
(1) Loosen the fixing screw to separate the cam-
era mounting base from the camera. Push up
the screwdriver once before removing the
screw.
(2) Turn the camera mounting base approximately
15 degrees counterclockwise and remove the
base from the camera.
2. Setting Switches
The camera is provided with an 8-bit DIP switch.
The 8-bit DIP switch is used to return the camera to
the factory default settings. Switch settings are
read into the camera when the power is turned on.
Make sure to turn the camera off, then turn it back
on after changing the switch settings. Switch posi-
tions and functions are shown below.
Note: When taking these procedures, keep the
power turned on until initialization of the
Camera Servo Control is completed.
Camera mounting base
Camera
Camera mounting
base
Fixing screw
Loosen and
push
15 °
Turn 15
°
Then
Camera
mounting base
Remove
from the
camera
Dip SW
Position
DIP
SW1
DIP
SW2
1 OFF OFF Normal
1 2 3 4
ON
5 6 7 8
8-bit DIP SW
Normal Position
1 2 3 4
ON
5 6 7 8
1 2 3 4
ON
5 6 7 8
1 2 3 4
ON
5 6 7 8
2 ON OFF Initializing the setup menu
3 OFF ON Initializing HTML files
4 ON ON
Initializing the setup menu
& HTML files
1 2 3 4
ON
5 6 7 8
8-bit DIP SW