0 arming, 1 exit delay timer, 2 regular arming – Paradox Hellas S.A. Digiplex EVO EVO96 User Manual

Page 9: 3 stay arming, 4 instant arming, 5 force arming, Arming

Advertising
background image

6 EVO96

4.0 Arming

When your system is armed, it can respond to any breach in the protected zones by causing an alarm and sending a report to
your monitoring station.

4.1 Exit Delay Timer

When you arm your system, it will trigger the Exit Delay Timer to provide you with enough
time to exit the protected area before the system is armed. The

light and the

appropriate arm icon will both flash during the exit delay on the DGP2-640

keypad. (Refer

to Table 1 on page 3)

4.2 Regular Arming

This method is used for the everyday arming of your system. All zones within the
protected area must be closed to Regular arm the system.

To Regular arm the system:

1. Enter your [

ACCESS

CODE

].

2. Press the [

ARM

] button or the [ ] key.

3. If you have access to more than one area, select the area(s) you wish to Regular arm

(refer to section 3.1 on page 5).

4.3 Stay Arming

Stay arming will partially arm your system to permit you to remain in your home or office
by arming the outer zones (perimeter) of the protected area (i.e. doors and windows).

To Stay arm:

1. Enter your [

ACCESS

CODE

].

2. Press the [

STAY

] button or the [

] key.

3. If you have access to more than one area, select the area(s) you wish to Stay arm

(refer to section 3.1 on page 5).

4.4 Instant Arming

This feature is the same as Stay arming except that there is no Entry Delay. Therefore,
any armed zone that is breached will immediately generate an alarm.

To Instant arm:

1. Enter your [

ACCESS

CODE

].

2. Press the [5] button.
3. If you have access to more than one area, select the area(s) you wish to Instant arm

(refer to section 3.1 on page 5).

4.5 Force Arming

Force arming allows you to quickly arm your system when zones are open. However,
once the open zone is closed, your system will then arm that zone as well.

To Force arm:

1. Enter your [

ACCESS

CODE

].

2. Press the [

FORCE

] button or the [ ] key.

3. If you have access to more than one area, select the area(s) you wish to Force arm

(refer to section 3.1 on page 5).

LCD

ICON

LED

LCD

ICON

LED

LCD

ICON

LED

LCD

ICON

LED

LCD

ICON

LED

Advertising